Hi,

I'm trying to connect a laptop to a Zywall 35 (Firewall+VPN) with Vista VPN.

I get an error in phase 2 of IKE from Zywall which complains that "[ID] :
Rule [] Verifying Remote ID failed: ".

The manual states that "Router identity consists of ID type and ID content.
The ID type can be IP address, domain name, or e-mail address, and the ID
content is a specific IP address, domain name, or e-mail address. The ID
content is only used for identification; the IP address, domain name, or
e-mail address that you enter does not have to actually exist.

The ZyWALL and the remote IPSec router each has its own identity, so each
one must store two sets of information, one for itself and one for the other
router. Local ID type and ID content refers to the ID type and ID content
that applies to the router itself, and peer ID type and ID content refers to
the ID type and ID content that applies to the other router in the IKE SA. "

The problem is that I can't find where to configure the following in Vista's
VPN:
Local ID Type
Local ID Content
Peer ID Type
Peer ID Content

It seems that Vista's VPN is always sending
Local ID Type: SINGLE
Local ID Content: the ip address of the Laptop

Where can I configure these 4 parameters in Windows Vista's VPN?

Thanks,