My laptop is HP2133, with window vista (+service pack 1 & 2). I've had bluescreen a few times. The latest information of bluescreen (from event viewer) is: Fault bucket 0xD1_processr!ReadGenAddr+11, type0

My laptop is HP2133, with window vista (+service pack 1 & 2). I've had bluescreen a few times. The latest information of bluescreen (from event viewer) is: Fault bucket 0xD1_processr!ReadGenAddr+11, type0

After downloading Windows updates and driver updates, my cd/dvd player does not work. I cannot install my printer or camara software because the player will not open. I took it to Frys (where I purchased)and was charged for a diagnostics test which they stated was not a hardware problem, but a software problem which the warranty did not cover. They then charged another fee for putting my...

I'm getting an error when I try to import video from a Canon DV video camera. It says that there is no tape in the camera. However, there is a tape in the camera and it is playing in the backgroud of Windows Import Video behind the error message. Any ideas?

Although this product claims to be Vista 64 capable will it run in MCE ? http://www.newegg.com/Product/Product.aspx?Item=N82E16815122012

I have a prior post ( see below ) where I swapped out 4 x 512 PC4200 and although Sony didnt state it dropped in 4 x 1meg 5300. First Windows expereince score was 5.9 and after the upgrade it dropped to 5.4. First batch was ildata & Crucial mix and these are all PNY. I think I'd like to go to 4 Crucial sticks as the PNY sticks werent allidentical ( couldnt tell till I opened the pack )....

I have sticks of DDR2 PC5300 running on a 533 bus. On a 667 bus the latency is published ot ne 5 but CPU ID states 4 @ 533. Have I got this correct ? Looking at replacing ram per prior post. I had a higher Windows EXP. score with pc4200 ram running at a 4 latency yes there is a cost advantage at the moment for the 5300 ram / 667 bus / 5 latency. I'd like ot put in the 5300 and let the MB...

I have a Sony desktop VGC-RA840G Pentium D running Ultimate 32 with 4 x 512 DDR2 4200 sticks. This is a dead silent water cooled machine I'd ike to keep. The specs call for that as the maximum although the chipset ( Intel 945P ) will go over 10. I'd like to run Ultimate 64. About a year or so ago I found a post about somene who upgraded to 4 x 1 meg sticks at the same speed...

I have a Sony desktop water cooled running a Pentium D 2.8 / Vista 32 Micro ATX and wanted to get the groups ideas on replacing the board / chip / memory with something that will beat the current Vista score of 4.7 for the CPU. Rest of components run at 5.9. No gaming at all I just want to be able to use my CAD and rendering programs much faster which are now using 100% CPU. Current PS is...

I use a Sony desktop Pentium D now 3.5 years old. I really like it as its very very quiet. Recently, during the prep of a new hard drive that requires a lot of cold starts using the on / off switch, an issue came up. After hitting the switch the machine powers up but doesn't get to the POST beep. It may take 4 / 5 attempts before I get a beep. Other than that the machine is completely...

I am running Ultimate on a Pentium D w/2meg and Ready Boost with a Seagate 7200 16 MB Cache on an Intel ICH7R/DH SATA Raid controller. I'm only using one disk and the original with the machine was a 150 type 1. I just updated the software for the controller to 8.6. I'm about to replace the hard drive with a WD 7200 with 32MB cache and wanted to ask the group for some advice. I am going...

I'm considering getting a new HDD with 32MB cache and installing Vista 64. The machine is a Pentium D running 2GB Memory with an Intel 945G chipset. I also use ReadyBoost quite successfully. I'll be installing some 32bit software afterwards. Appreciate all help and thoughts and cautions ?

I have a PNY USB stick configured for ReadyBoost. Runs great except is usually needs to be re-installed at every boot and restart. I've had this happen with two different sticks of the same brand. Anything I'm doing wrong here ? Why aren't these sticks detected at reboot ?

Has anyone had any luck using a Memory Stick ( 2GB and up ) in Vista ReadyBoost ?

Can anyone point me to an SD ( not SDHC ) 4 GB for ReADY bOOST ? My machine has an SD reader, xD reader, CF reader and memory stick....

Running a Sony Desktop with on board sound & 5.1 speakers / Vista 32. The only drive that would allow full speaker function is the XP driver from Sony. I have tried 1.78 & 1.79 and they allow marginal functionality along with crackling so I reverted to the XP sony drivers. Allwas well then Pook ! no sound and I cant unistall and start from scratch. I have deleted the HDF audio from...

I'm looking for a good and free HDD wipe utility I can run from its own boot CD. I'm donating a HDD and dont want and cant have the data on the drive after it leaves my hands. TIA.

I have a Sony laptop ( 2 years old ). Sont is not supporting it for Vista but through trial and error I have gotten everything to work except the VGA ouput. It runs through the first boot screens bu no joy after that. I have installed all the same or similar drivers from Sony for machines similar and still nothing. Iwas wondering if there was any experiens out there as to how to get this...

I did a fresh install of Home Premium and have lost the use of my Memory Stick reader. The XP driver doesnt seem to help. I went thr ough a similar thing with a desktop and a TV card from Sony and the XP drivers did the trick but in this case no. TIA.

Installed a Canon FB620U in Vista Ultimate and it scnas into Office scan just fine. Vista FAx & Scan does not see the scanner. Any ideas appreciated.