I finally got it working and for those who have the same printer, here is how
I did it.

I uninstalled the software, and deleted the printer from the system. I
then, went on line and downloaded the updated software (did not use the cd
rom that was included with the printer). It ran through the installation
process, telling when to connect the Printer via the USB port, and then
finally asking about the printheads (I bought new ones today and installed
them too), and then it did a test page, which I was glad to see and hear.
So, it is now installed and working. So, patience and a little ingenuity
will always let you succeed. So, long story short. It is now working.

"FlBoy55" wrote:

I give up, but will keep returning to see if anyone else has some ideas?
Another driver release for Emachines Computer with Vista.

"Colin Barnhorst" wrote:

Check the printer's manual. Some printers need to be off and disconnected
while you install the software. This is usually true of HP printers and
scanners. Just the reverse of a lot of PnP devices.

"FlBoy55" wrote in message
...
I tried it again, but still not printing. Any other ideas. Should I try
removing and re-installing? Windows 98 suggested that in the past. So,
does
Windows Vista require the same on such matters?

"FlBoy55" wrote:

I did download the drivers from Lexmark site, but will try again.

"DL" wrote:

http://downloads.lexmark.com/cgi-per...29:1:0:432:0:0
Install the drivers

"FlBoy55" wrote in message
...
I have a Lexmark Printer which worked with Windows 98. Now it won't
work
with
my new Emachines computer with Windows Vista Home Premium. I have
downloaded
the recommended updates, but all I seem to get is the documents put
in the
queue, but does not send to the printer to begin printing. Anyone
got any
ideas.