Hello everybody.

I hope anybody here may help me.

I have the following problem:
I want to instll Vista RC1 on a computer equiped with a Asus P5B del/Wifi,
2x Hitchi 80Gb SATAII drives. Everybody works fine until I chose the
destination drive for installation... De Raid0 partition shows up, I select
it and create 1 partition, I click Next and then I get followin message:

Windows could not determin if this Computer contains avalid system Volume !!!

Does anybody may help me? I would be so happy

PS: I connected HD on SATA1 and SATA2 (red, master) ports, activated RAID
mode in Bios for ICH8R Southbridge chip but not for JMicron Raid

You probably will need to install ICH8R RAID driver at the stage where you
select your partition. I have the same mobo, didn't use raid but AHCI.
Can't complete install of RC1 until I installed the IATA6.1 x64 driver at
the stage where I had to select which hd part to install to, despite the
fact that the RC1 setup can see all my drives.....
"Mich" wrote in message
...
Hello everybody.

I hope anybody here may help me.

I have the following problem:
I want to instll Vista RC1 on a computer equiped with a Asus P5B del/Wifi,
2x Hitchi 80Gb SATAII drives. Everybody works fine until I chose the
destination drive for installation... De Raid0 partition shows up, I
select
it and create 1 partition, I click Next and then I get followin message:

Windows could not determin if this Computer contains avalid system Volume
!!!

Does anybody may help me? I would be so happy

PS: I connected HD on SATA1 and SATA2 (red, master) ports, activated RAID
mode in Bios for ICH8R Southbridge chip but not for JMicron Raid